When buying electrical equipment what does it propose when they right to be heard (24bit 96khz)??
i know the answer may seem very natural to a lot of people but i no nil about electronics.
i want to buy a sound card and it say its 24bit 96khz.. what on earth does that mean??
Answers:
nice nouns card ;-) my new rme one will be 24bit 96khz also, 32 channel.
its for music , from what you wrote? build sure also the asio drivers are good + low latency less than 10 ms.. the lower the better.
24bit.. is of late how many bits it plays back at / annals..
e.g. cd player is 44.1 + 16 bit (so half the 96)
it's just the competence of it.. if its for music, then yep 96 / 24 is good =)
the difference between 96 + 44.1 you can hear, it have double the frequency range..
also the 24 bit.. is the range it can support.. so articulate you make mix a tune at 24 bit.. you notice the difference..
ironic though, you own to dither it down to 16bit for cd players.. but you have a far better frequency range if its 24 bit + 96khz as you own a far bigger range mixing wise. Source(s): i used to install/sell pro audio gear for lots chart acts.
i make music
www.thehowtoguides.org
Related Questions:
When should we start our business? We hold adjectives the equipment and everything we inevitability, of late a touch afraid..?
Give a brief description of procedures required for the following:equipment safekeeping mutual audit?
If they enjoy the proper equipment, are psychiatrists qualified to run drug test?
Where are some places where on earth you could buy backpacking equipment or similar to outdoor things?
What device can i use to convey an infrared signal from a remote control to equipment contained by a closet 60 ft away?
i want to buy a sound card and it say its 24bit 96khz.. what on earth does that mean??
Answers:
nice nouns card ;-) my new rme one will be 24bit 96khz also, 32 channel.
its for music , from what you wrote? build sure also the asio drivers are good + low latency less than 10 ms.. the lower the better.
24bit.. is of late how many bits it plays back at / annals..
e.g. cd player is 44.1 + 16 bit (so half the 96)
it's just the competence of it.. if its for music, then yep 96 / 24 is good =)
the difference between 96 + 44.1 you can hear, it have double the frequency range..
also the 24 bit.. is the range it can support.. so articulate you make mix a tune at 24 bit.. you notice the difference..
ironic though, you own to dither it down to 16bit for cd players.. but you have a far better frequency range if its 24 bit + 96khz as you own a far bigger range mixing wise. Source(s): i used to install/sell pro audio gear for lots chart acts.
i make music
www.thehowtoguides.org
Related Questions:
